| DRILLING DEPTH | - 400 m en HQ |
| DRILLING DIAMETERS | - Up to 200 mm. with conventional drilling system and HQ. |
| ENGINE | - Diesel DEUTZ modelo D914 L5 (98 C.V.), 2.300 r.p.m. |
| ROTATION HEAD | - 100mm. pitch striated hollow shaft
– Thread for coupling direct rotation |
| ROTATION SPEED | - From 0 to 1.200 r.p.m.
– Variable from control panel |
| MAXIMUM TORQUE | - 650 Kgm |
| HYDRAULIC CLAMP | - Installed on head
– 90mm (HQ) diameter rod capacity |
| HYDRAULIC RETAINER | - Guide and retention capacity until 200 mm.
– Dual retainer releaser |
| HEAD TRAVEL | - 3.400 mm |
| MAXIMUM TRACTION | - 9.000 Kg |
| THRUST | - Adjustable from 0 to 4.000 Kg. |
| DRILLING ANGLE | - From 0º to 90º |
| LONGITUDINAL SLIDE STROKE | - 800 mm |
| CONTROL PANEL | - Centralised with full hydraulic system and adjustable speed of advance and thrust or retention force
– Rotation pressure, thrust and injection pump intakes, enabling the recording of drilling parameters |
| WINCH | - 3.000 Kg. capacity in direct pull |
| WIRE LINE WINCH | - 1,000 kg capacity in direct pull
– 200 mt. of cable Ø 6mm. |
| LEVELING | - Four cylinders with adjustable plate and control by check valves |
| WATER PUMP | - Regulated flow from 0 to 200 l.p.m.
– Regulated pressure from 0 to 50 bar. |
| SPT BEATING UNIT | - Installed on the equipment
- Self-operated without a winch
- Beating hammer weight 63,5 Kg.
- Free fall height 76 cm.
- Electronic digital beat counter
- Adjustable beating regime between 20 and 30 beats p.m.
- Complies with the UNE-EN-ISO 22476-2: 2008 standard |
| WEIGHT | - 4.770 Kg |
| |